Publications

• Chapitre d'ouvrage

Trois expériences d'apprentissage par les problèmes

Jean-Paul Becar, Jean-Charles Canonne, Fabrice Robert, Eric Cartignies, Aurel Fratu, Mariana Fratu, Désiré Dauphin Rasolomampionona

Le projet : les pratiques en IUT, Contribution au chapitre IV- Articuler l’approche projet et le pilotage institutionnel, L’Harmattan, pp.106-110, 2016, 978-2-343-10803-2. ⟨hal-02508572⟩

• Article dans une revue

Experimental Study of Heat and Mass Transfer for Liquid Film Evaporation along a Vertical Plate Covered With a Porous Layer

Amine Terzi, Sadok Ben Jabrallah, Souad Harmand

In this paper, we realized an Experimental study of heat and mass transfer for liquid evaporation along a vertical plate covered with a porous layer. To develop this study, an experimental dispositive was realized. To highlight the effect of the addition of a porous layer on the phenomenon of…

Journal of Applied Fluid Mechanics, 2016, Selected papers from the 7thInternational Exergy, Energy and Environment Symposium, IEEE7-2015, 9 (Special issue 1), pp.113-120. ⟨10.36884/jafm.9.SI1.25821⟩. ⟨hal-03447185⟩

• Article dans une revue

Local stability of discrete-time TS fuzzy systems

Zsofia Lendek, Jimmy Lauber

This paper considers local stability analysis of discrete-time Takagi-Sugeno fuzzy systems, for which classically in the TS literature only global stability is considered. Using a common quadratic and nonquadratic Lyapunov function, respectively, LMI conditions are developed to establish local…

IFAC-PapersOnLine, 2016, 49 (5), pp.7-12. ⟨10.1016/j.ifacol.2016.07.081⟩. ⟨hal-03669983⟩

• Article dans une revue

Multiscale roughness analysis of engineering surfaces: A comparison of methods for the investigation of functional correlations

Gaëtan Le Goïc, Maxence Bigerelle, Serge Samper, Hugues Favrelière, Maurice Pillet

This study investigates the correlations between the topography of different damaged rough surfaces and process conditions. Several surfaces are measured and compared to determine if they can be discriminated. The analysis is performed by using Gaussian Filtering, Wavelet Transform and a more…

Mechanical Systems and Signal Processing, 2016, 66-67, pp.437-457. ⟨10.1016/j.ymssp.2015.05.029⟩. ⟨hal-01202891⟩

• Article dans une revue

Experimental Investigations on Oscillatory Couette Taylor Flow Wall Shear Stress Behavior using Electrochemical Technique: Low Modulation Effect

Emna Berrich, Fethi Aloui, Jack M Legrand

In the simplest and original case of study of the Taylor–Couette TC problems, the fluid is contained between a fixed outer cylinder and a concentric inner cylinder which rotates at constant angular velocity. Much of the works done has been concerned on steady rotating cylinder(s) i.e. rotating…

Journal of Applied Fluid Mechanics, 2016, 9 (1), pp.147-154. ⟨10.36884/jafm.9.SI1.26163⟩. ⟨hal-02545268⟩

• Proceedings/Recueil des communications

Service Orientation in Holonic and Multi-agent Manufacturing

Theodor Borangiu, Damien Trentesaux, André Thomas, Duncan Mcfarlane

Of interest are recent advances and on-going research in holonic and agent-based systems for manufacturing. Industrials are seeking for models and solutions that are not only able to provide efficient overall production performance, but also to face reactively a growing set of unpredicted events.…

2016, Service Orientation in Holonic and Multi-agent Manufacturing, 978-3-319-30335-2. ⟨10.1007/978-3-319-30337-6⟩. ⟨hal-01425754⟩

• Article dans une revue

Experimental Study of Flow Control on Bluff Body using Piezoelectric Actuators

Nabil Tounsi, Rafika Mestiri, Laurent Keirsbulck, Hamid Oualli, Samir Hanchi, Fethi Aloui

Active flow control is experimentally investigated on a car-type bluff body. The actuation is based on a synthetic jet actuator placed at the top of the Ahmed body rear window. In the present paper, a synthetic jet characterization is presented, the frequencies and the optimal amplitudes with…

Journal of Applied Fluid Mechanics, 2016, 9 (2), pp.827-838. ⟨10.18869/acadpub.jafm.68.225.24488⟩. ⟨hal-03448166⟩

• Communication dans un congrès

Modeling transistor level masking of soft errors in combinational circuits

Ihsen Alouani, Smail Niar, Yassin El Hillali, Atika Rivenq

Technology scaling in modern electronic circuits shrinks the transistor size and dramatically increases the sensitivity of semiconductor devices to radiations. Consequently, soft errors emerged as a serious reliability threat in both sequential and combinational circuits. To accurately estimate…

2015 IEEE East-West Design and Test Symposium, EWDTS 2015, Sep 2015, Batumi, United States. pp.7493140, ⟨10.1109/EWDTS.2015.7493140⟩. ⟨hal-03528693⟩

• Communication dans un congrès

A co-design space exploration tool for avionic high performance heterogeneous embedded architectures

Geoffroy Pertuisot, Nicolas Belanger, Yassin El Hillali, Smail Niar, Atika Rivenq

Avionics in the helicopter manufacturers' landscape faces new challenges. Whereas customers raise continuously their needs in terms of new functions and embedded systems performances, certification authorities maintain complex rules to fulfill for parallel computing. This constraining…

11th International Design and Test Symposium, IDT 2016, Dec 2016, Hammamet, Tunisia. pp.77-82, ⟨10.1109/IDT.2016.7843018⟩. ⟨hal-03528686⟩

• Communication dans un congrès

An Approach for the Selection of Evaluation Methods for Interactive Adaptive Systems Using Analytic Hierarchy Process

Amira Dhouib, Abdelwaheb Trabelsi, Christophe Kolski, Neji Mahmoud

The evaluation of interactive adaptive systems is the source of many difficulties for novice evaluators as well as for expert ones. Issues arise in the need to identify the appropriate evaluation methods to be used for a given evaluation context. This paper proposes an approach for the choice of…

10th International Conference on Research Challenges in Information Science, RCIS 2016, Institute of Electrical and Electronics Engineers(IEEE), May 2016, Grenoble, France. pp.411-420, ⟨10.1109/RCIS.2016.7549289⟩. ⟨hal-03350506⟩